Roof Acrylic Base Waterproofing Paint

Product Description:

Leveraging on our intelligent professionals, we are presenting a wide assortment of Acrylic Base Waterproofing Paint for Terrace and roof. It is an elastomeric, flexible single pack waterproofing membrane made out of 100% pure acrylic polymers under the advanced technical assistance. It is used for filling hair line cracks on walls and terrace. It gives a smooth and sheen finish to all surfaces. It has been tested by recognized institution to authenticate its effectiveness. Besides, clients can get the paint from us at cost effective rates.

Features:

• Having low water absorption
• Providing for high alkali resistance
• Allows low dirt pick up

• Gives excellent waterproofing.
• Washable and Scrub resistant.
• It eliminates the requirement of any other primer coat.
• Excellent resistance to algae and fungus.
• Being elastic in nature it allows minor structural movements.

• On Smooth Surface,1Kg Sealercoat Covers Approximately 20 sqft in 2 coats.

• Surface Preparation:-Clean the surface with adequate quantity of water. Make surface dust & grease free; remove all previous coatings which may have loose bond with the surface. If required, scrub with wire brush or use scrapper to remove old flake, chips & dust
• Filling of Cracks :-Weather cracks are the cause of water/leakages thru wall and roofs ofbuildings. In case of a presence of prominent surface cracks please fill up the cracks with Diamond shield or any good quality crack filler before applying sealercoat
• Primer Coat:- Old, uneven and highly porous cement surfaces absorb essential polymers of Sealercoat. Hence- apply one or two coats of Sealoxy Primer or any other water based Undercoat for the best results and good finish.
• Final Finish:-Apply two Coats of Diluted Sealercoat with 15% water & should be applied with an interval of 3 to 4 hours between two coats.

• Surface Preparation:- Clean the surface and make it dust, grease & Oil free and then apply a coat of good quality zinc phosphate primer to avoid corrosion of the metal sheet.
• Joint Filling: Between the overlaying joints of Galv. / Asb. Sheets, insert cotton bedding orgauze, soaked & dipped in un diluted Sealercoat for at least 2 inch in depth. (Length wise). Galvanized “J” bolts may be covered with cotton gauze dipped in undiluted Sealercoat & liberally wrapped around the bolt to cover sufficient area.

• 500 gms
• 1 Kg
• 5 Kg
• 27 Kg
• 50 Kg

• Minimum Order Quantity: 100 Kilogram